سلام
من تازه یدونه UNO گرفتم.
برنامش رو هم نصب کردم، اما نمی دونم چرا نمی تونم پورت رو انخاب کنم؟؟؟
لطفا راهنماییم کنید.
تشکر.
دلیل: ادغام دو پست برای جلوگیری از اسپم
موقع آپلود یه برنامه هم خطای زیر رو می ده:
Arduino: 1.8.4 (Windows 8.1), Board: "Arduino/Genuino Uno"
Sketch uses 928 bytes (2%) of program storage space. Maximum is 32256 bytes.
Global variables use 9 bytes (0%) of dynamic memory, leaving 2039 bytes for local variables. Maximum is 2048 bytes.
avrdude: ser_open(): can't open device "\\.\COM1": The system cannot find the file specified.
Problem uploading to board. See http://www.arduino.cc/en/Guide/Troubleshooting#upload for suggestions.
This report would have more information with
"Show verbose output during compilation"
option enabled in File -> Preferences.
من تازه یدونه UNO گرفتم.
برنامش رو هم نصب کردم، اما نمی دونم چرا نمی تونم پورت رو انخاب کنم؟؟؟
لطفا راهنماییم کنید.
تشکر.
دلیل: ادغام دو پست برای جلوگیری از اسپم
موقع آپلود یه برنامه هم خطای زیر رو می ده:
Arduino: 1.8.4 (Windows 8.1), Board: "Arduino/Genuino Uno"
Sketch uses 928 bytes (2%) of program storage space. Maximum is 32256 bytes.
Global variables use 9 bytes (0%) of dynamic memory, leaving 2039 bytes for local variables. Maximum is 2048 bytes.
avrdude: ser_open(): can't open device "\\.\COM1": The system cannot find the file specified.
Problem uploading to board. See http://www.arduino.cc/en/Guide/Troubleshooting#upload for suggestions.
This report would have more information with
"Show verbose output during compilation"
option enabled in File -> Preferences.
دیدگاه